￠600-￠1200PE/PP DWC corugated pipe extruder line

Dwc1200 high speed water cooled PE double wall corrugated pipe production line

Equipment composition and configuration description

The production line can produce PE / PP double wall bellows with a maximum outer diameter of 1200mm. The installed capacity of the production line is 1100kw and the common power is 710KW. Cooling water requirements: ≤ 15 ℃, 0.2-0.3mpa, 0.7m3/min. Compressed air requirements: 0.3m3/min, ≥ 0.6MPa. The overall dimension of the production line is about 38m × 7.5m × 4.5m ( L*W*H)

Equipment composition of production line

1.Single screw extruder SJ150/33 1 set With automatic feeder and dryer

2 Single screw extruder SJ150/33 1 set With automatic feeder and dryer

3 High speed water-cooled corrugated forming machine DWC-1200 1 set

4 Spray cooling water tank Type 1200 1 set

5 Automatic chip free cutting machine Type 1200 1 set

6 Plastic pipe blanking rack Type 1200 1 set

Equipment configuration and performance introduction of production line

Sj-150 / 33 single screw extruder 1 set

2.1 screw diameter: 150mm;

2.2 length diameter ratio of screw: 33:1;

2.3 screw speed: 7-75r / min;

2.4 material of screw and barrel: 38CrMoAlA, nitriding and grinding;

2.5 driving power: 315KW, DC motor, DC speed regulation;

2.6 screw structure: high efficiency barrier screw with special mixing section, which greatly improves the plasticization quality and output;

2.7 barrel structure: the asymmetric slotted barrel design is adopted, and the feed inlet is equipped with a water cooling system with automatic temperature control to double the conveying efficiency of the feed section;

2.8 reduction gearbox: the reduction gearbox adopts vertical structure, and the cooling mode is forced circulating oil cooling, with circulating water cooling system. High torque, low noise, hard tooth surface gear, gear grinding process, plus heavy thrust bearing;

2.9 automatic feeder and dryer: imported from Taiwan Xinyi. The automatic feeder is of inductive design, with a conveying capacity of 1200 kg / h and a shortage alarm function. The dryer adopts the integrated design of drying and material storage, automatic temperature control and intelligent display, with a hopper volume of 200L and full stainless steel lining;

2.10 temperature control: PCC control system, double PID temperature control, temperature control accuracy ± 1 ℃.speed control: PCC control system, stable and stepless adjustment of operation speed, and synchronous adjustment of several equipment.

The extruder is equipped with 12.2 guide rails and a moving device for adjusting the height of the center.

DWC TUBE DOUBLE ASSAINISSEMENT1 60-500MM